lm_output_command

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Last revisionBoth sides next revision
lm_output_command [2017/10/10 16:59] wikiadminlm_output_command [2017/10/11 09:36] wikiadmin
Line 1: Line 1:
 ===== Command ===== ===== Command =====
  
-{{ :logic_icons_internalstatus.png?100 |}}+{{ :logic_icons_command.png?nolink&220 |}}
  
 It represents the command to be executed when a value on the input connector is received. It represents the command to be executed when a value on the input connector is received.
  
-  * **KNX group**: the KNX group address. +  * **Trigger** It determines the behaviour of the node for the command execution: 
-  * **Output type**the datatype of the value to write on KNX.+    * //On trigger// If selected, a new **Trigger** input connector is added to the node, which executes the command whenever the connector value is 1 (or 0 if the connector is inverted) 
 +    * //On parameter value change// If selected and the parameters are input connectors of the node, whenever the value of an input connector is updated, executes the command 
 +  * **Command** It is the command to execute. If the selected command has parameters, they are added to the property grid as new node properties, and for each parameter it is possible to assign a value or to make it become an input connector for the node so that the value for the parameter is dynamic.
  • lm_output_command.txt
  • Last modified: 2019/03/20 17:04
  • by 127.0.0.1