lm_output_command

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
lm_output_command [2017/10/10 16:59] wikiadminlm_output_command [2019/03/20 17:04] (current) – external edit 127.0.0.1
Line 1: Line 1:
 ===== Command ===== ===== Command =====
  
-{{ :logic_icons_internalstatus.png?100 |}}+{{ :logic_icons_command.png?nolink&220 |}}
  
 It represents the command to be executed when a value on the input connector is received. It represents the command to be executed when a value on the input connector is received.
  
-  * **KNX group**: the KNX group address. +  * **Trigger** It determines the behaviour of the node for the command execution: 
-  * **Output type**the datatype of the value to write on KNX.+    * //On trigger// If selected, a new **Trigger** input connector is added to the node, which executes the command whenever the connector value is 1 (or 0 if the connector is inverted) 
 +    * //On parameter value change// If selected and the parameters are input connectors of the node, whenever the value of an input connector is updated, executes the command 
 +  * **Command** It is the command to execute. If the selected command has parameters, they are added to the property grid as new node properties, and for each parameter it is possible to assign a value or to make it become an input connector for the node so that the value for the parameter is dynamic.
  • lm_output_command.1507647568.txt.gz
  • Last modified: 2019/03/20 17:03
  • (external edit)