lm_timer_stopwatch

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Next revisionBoth sides next revision
lm_timer_stopwatch [2017/09/29 10:28] – created wikiadminlm_timer_stopwatch [2017/09/29 10:59] – wikiadmin
Line 9: Line 9:
 When the **Reset** connector value is 1, the node stops counting the time and sends 0 to both **Partial time** and **Total** time, it will start counting again only after the **Reset** value goes to 0. When the **Reset** connector value is 1, the node stops counting the time and sends 0 to both **Partial time** and **Total** time, it will start counting again only after the **Reset** value goes to 0.
  
-{{ :diagram_pulsegen2.png | Behaviour of Continuous Pulse Generator }} +{{ :diagram_stopwatch_switch.png | Behaviour of Stopwatch with Trigger policy //Switch// }} 
-<WRAP center 60%> <WRAP centeralign> Behaviour of Continuous Pulse Generator </WRAP>  </WRAP>+<WRAP center 60%> <WRAP centeralign> Behaviour of Stopwatch with Trigger policy //Switch// </WRAP>  </WRAP> 
 + 
 +{{ :diagram_stopwatch_toggle.png | Behaviour of Stopwatch with Trigger policy //Toggle// }} 
 +<WRAP center 60%> <WRAP centeralign> Behaviour of Stopwatch with Trigger policy //Toggle// </WRAP>  </WRAP>
  • lm_timer_stopwatch.txt
  • Last modified: 2019/03/20 17:04
  • by 127.0.0.1