Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
lm_timer_stopwatch [2017/09/29 10:28] – created wikiadmin | lm_timer_stopwatch [2017/09/29 11:10] – wikiadmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Stopwatch ===== | ===== Stopwatch ===== | ||
- | {{ : | + | {{ : |
- | The Stopwatch node measures | + | The Stopwatch node measures |
- | There are two modalities to determine how the Stopwatch | + | * //Switch// The Stopwatch |
- | * //Switch// The Stopwatch | + | * //Toggle// The Stopwatch starts counting when it receives |
- | * //Toggle// The Stopwatch starts counting when it receives | + | |
When the **Reset** connector value is 1, the node stops counting the time and sends 0 to both **Partial time** and **Total** time, it will start counting again only after the **Reset** value goes to 0. | When the **Reset** connector value is 1, the node stops counting the time and sends 0 to both **Partial time** and **Total** time, it will start counting again only after the **Reset** value goes to 0. | ||
- | {{ :diagram_pulsegen2.png | Behaviour of Continuous Pulse Generator | + | {{ :diagram_stopwatch_switch.png | Behaviour of Stopwatch with Trigger policy // |
- | <WRAP center 60%> <WRAP centeralign> | + | <WRAP center 60%> <WRAP centeralign> |
+ | |||
+ | {{ : | ||
+ | <WRAP center 60%> <WRAP centeralign> |