system_objs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
system_objs [2020/01/14 10:12] – [System] ingridsystem_objs [2020/01/14 20:36] – [System] ingrid
Line 88: Line 88:
   * **Clients Ph. Address Base** base physical address for the clients connections.   * **Clients Ph. Address Base** base physical address for the clients connections.
   * **Client number** number of supported client tunnel connections.   * **Client number** number of supported client tunnel connections.
-  * **KNXNet/IP router** If enabled, the server will also route traffic from TP to multicast IP and thus can be used the same way as line coupler.+  * **KNXNet/IP router** If enabled, the server will also route traffic from TP to multicast IP and vice versa, allowing to connect different parts of KNX system together over IP. More information are available on the [[knxnet_ip| KNXnet/IP]] guide.
   * **System name** Name to identify the project once it has been uploaded to the server.   * **System name** Name to identify the project once it has been uploaded to the server.
   * **Location** Name of the location where the system is installed.   * **Location** Name of the location where the system is installed.
  • system_objs.txt
  • Last modified: 2024/03/16 09:42
  • by wikiadmin