system_objs

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
system_objs [2020/01/14 20:36] – [System] ingridsystem_objs [2020/01/14 20:37] – [System] ingrid
Line 84: Line 84:
   * **Server client port** Number of the TCP port needed to remotely connect with the server (outside the server network). The default port is 7550.   * **Server client port** Number of the TCP port needed to remotely connect with the server (outside the server network). The default port is 7550.
   * **Local IP address** IP address (for example 192.168.X.X) needed to connect with the server from clients that operate in the server LAN.   * **Local IP address** IP address (for example 192.168.X.X) needed to connect with the server from clients that operate in the server LAN.
-  * **KNXNet/IP interface** if enabled, the Thinknx server can be used as a KNXNet/IP interface, allowing KNX programming from the ETS software for example.+  * **KNXNet/IP interface** if enabled, the Thinknx server can be used as a KNXNet/IP interface, allowing KNX programming from the ETS software for example. More information are available on the [[knxnet_ip| KNXnet/IP]] guide.
   * **KNXNet/IP different IP** if enabled, permits to choose a different KNXNet/IP interface to connect and access the KNX bus.   * **KNXNet/IP different IP** if enabled, permits to choose a different KNXNet/IP interface to connect and access the KNX bus.
   * **Clients Ph. Address Base** base physical address for the clients connections.   * **Clients Ph. Address Base** base physical address for the clients connections.
  • system_objs.txt
  • Last modified: 2024/03/16 09:42
  • by wikiadmin