Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision Next revisionBoth sides next revision | ||
generic_commands [2019/04/02 08:48] – [Reports and Gateways] ingrid | generic_commands [2019/04/02 08:55] – [Reports and Gateways] ingrid | ||
---|---|---|---|
Line 111: | Line 111: | ||
* [[# | * [[# | ||
* [[# | * [[# | ||
- | * Serial Gateway | + | * [[# |
- | * Ethernet Gateway | + | * [[# |
* Gateway MyHome | * Gateway MyHome | ||
* Voice Control Gateway | * Voice Control Gateway | ||
Line 179: | Line 179: | ||
++++ | ++++ | ||
++++Select Level Lights| This command is used to send the lights to a certain level. | ++++Select Level Lights| This command is used to send the lights to a certain level. | ||
- | * **Output integration ID** ID of the output to control. | + | |
* **Level** Input a number between 0 and 255 to send the lighting level. | * **Level** Input a number between 0 and 255 to send the lighting level. | ||
++++ | ++++ | ||
++++Select Raising Lights| This command is used to start raising the lighting level of the desired output. | ++++Select Raising Lights| This command is used to start raising the lighting level of the desired output. | ||
- | * **Output integration ID** ID of the output to control. | + | |
++++ | ++++ | ||
++++Select Lowering Lights| This command is used to start lowering the lighting level of the desired output. | ++++Select Lowering Lights| This command is used to start lowering the lighting level of the desired output. | ||
- | * **Output integration ID** ID of the output to control. | + | |
++++ | ++++ | ||
++++Stop Raising or Lowering Lights| This command is used to stop raising/ | ++++Stop Raising or Lowering Lights| This command is used to stop raising/ | ||
- | * **Output integration ID** ID of the output to control. | + | |
+ | ++++ | ||
+ | |||
+ | === Serial Gateway === | ||
+ | The available commands when selecting the **Serial Gateway** category under **Reports and Gateways** are the following: | ||
+ | |||
+ | ++++Send string with no termination| This command is used to send a string without termination. | ||
+ | * **String to send** input the string that will be sent to the serial gateway. | ||
+ | ++++ | ||
+ | ++++Send string with CR termination| This command is used when sending a string with CR termination, | ||
+ | * **String to send** input the string that will be sent to the serial gateway. | ||
+ | ++++ | ||
+ | ++++Send hexadecimal string with no termination| This command is used to send an hexadecimal string without termination. | ||
+ | * **String to send** input the string that will be sent to the serial gateway. | ||
+ | ++++ | ||
+ | ++++Send hexadecimal string with CR termination| This command is used when sending an hexadecimal string with CR termination, | ||
+ | * **String to send** input the string that will be sent to the serial gateway. | ||
++++ | ++++ |