Differences

This shows you the differences between two versions of the page.

--- generic_commands [2019/04/02 08:48] – [Reports and Gateways] ingrid
+++ generic_commands [2019/04/02 08:56] – [Reports and Gateways] ingrid
@@ Line 111: / Line 111: @@
   * [[#gateway_modbus| Gateway Modbus]]
   * [[#lutron_project| Lutron Project]]
-  * Serial Gateway
+  * [[#serial_gateway| Serial Gateway]]
-  * Ethernet Gateway
+  * [[#ethernet_gateway| Ethernet Gateway]]
   * Gateway MyHome
   * Voice Control Gateway
@@ Line 179: / Line 179: @@
 ++++
 ++++Select Level Lights| This command is used to send the lights to a certain level.
- * **Output integration ID** ID of the output to control.
+  * **Output integration ID** ID of the output to control.
   * **Level** Input a number between 0 and 255 to send the lighting level.
 ++++
 ++++Select Raising Lights| This command is used to start raising the lighting level of the desired output.
- * **Output integration ID** ID of the output to control.
+  * **Output integration ID** ID of the output to control.
 ++++
 ++++Select Lowering Lights| This command is used to start lowering the lighting level of the desired output.
- * **Output integration ID** ID of the output to control.
+  * **Output integration ID** ID of the output to control.
 ++++
 ++++Stop Raising or Lowering Lights| This command is used to stop raising/lowering the lighting level of the desired output.
- * **Output integration ID** ID of the output to control.
+  * **Output integration ID** ID of the output to control.
+++++
+=== Serial Gateway ===
+The available commands when selecting the **Serial Gateway** category under **Reports and Gateways** are the following:
+++++Send string with no termination| This command is used to send a text without termination.
+  * **String to send** input the string that will be sent to the serial gateway.
+++++
+++++Send string with CR termination| This command is used when sending a text with CR termination, marking the end of the line.
+  * **String to send** input the string that will be sent to the serial gateway.
+++++
+++++Send hexadecimal string with no termination| This command is used to send an hexadecimal string without termination.
+  * **String to send** input the string that will be sent to the serial gateway.
+++++
+++++Send hexadecimal string with CR termination| This command is used when sending an hexadecimal string with CR termination, marking the end of the line.
+  * **String to send** input the string that will be sent to the serial gateway.
 ++++