Differences
This shows you the differences between two versions of the page.
Next revision | Previous revisionLast revisionBoth sides next revision | ||
lm_output_command [2017/10/10 16:58] – created wikiadmin | lm_output_command [2017/10/11 09:36] – wikiadmin | ||
---|---|---|---|
Line 1: | Line 1: | ||
===== Command ===== | ===== Command ===== | ||
- | {{ :logic_icons_knxinput.png?100 |}} | + | {{ :logic_icons_command.png?nolink& |
- | It represents the command to be executed when an input is received. | + | It represents the command to be executed when a value on the input connector |
- | * **KNX group**: the KNX group address. | + | * **Trigger** It determines the behaviour of the node for the command execution: |
- | * **Output type**: the datatype of the value to write on KNX. | + | * //On trigger// If selected, a new **Trigger** input connector is added to the node, which executes the command whenever the connector value is 1 (or 0 if the connector is inverted) |
+ | * //On parameter value change// If selected and the parameters are input connectors of the node, whenever the value of an input connector is updated, executes the command | ||
+ | * **Command** It is the command to execute. If the selected command has parameters, they are added to the property grid as new node properties, and for each parameter it is possible to assign a value or to make it become an input connector for the node so that the value for the parameter is dynamic. |