Differences

This shows you the differences between two versions of the page.

--- alarm_device [2019/03/12 09:18] – created ingrid
+++ alarm_device [2020/08/18 11:39] – ingrid
@@ Line 31: / Line 31: @@
     * //RS232overTCP_IP:// Connected through link with TCP media converter.
     * //TCP_IP:// Connected through network link.\\ If the property ”Communication” is set to ”RS232”, the following properties will appear:
-      * Serial Port: This property represents the system serial port number.\\ If the property ”Communication” is set to ”TCP/IP”, the following properties will appear:
+      * Serial Port: Serial port number that changes depending on the server used. Click [[port_numbers| here]] to get the correct port number. \\ If the property ”Communication” is set to ”TCP/IP”, the following properties will appear:
       * IP Address: Device IP address or RS232overIP address.
       * Port Number: TCP/IP port number for ethernet connection.
@@ Line 51: / Line 51: @@
      * Passphrase: Encryption passphrase used during panel configuration.
+==== Object Commands ====
+After adding an alarm device to the system, it is possible to send a number of commands when using other objects such as the Generic Command button.
+<WRAP centeralign>{{ :gen_cmd_5.png?400 | Security }}</WRAP>
+After selecting **Security** from the tree, a list of all the alarm devices and centrale added in System will be shown. The available commands when selecting one of the devices are the following:
+++++Arm a particular partition with a specified code|  This command will allow to arm one partition using its related pin code.
+  * **Partition Number**
+  * **Pin Code**
+++++
+++++Disarm a particular partition with a specified code|  This command will allow to disarm one partition using its related pin code.
+  * **Partition Number**
+  * **Pin Code**
+++++
+++++Arm all partitions with a specified code|  This command will allow to arm all partition using a common pin code.
+  * **Pin Code**
+++++
+++++Disarm all partitions with a specified code|  This command will allow to disarm all partition using a common pin code.
+  * **Pin Code**
+++++
+++++Switch ON or OFF the specified output|  This command will allow to control a particular output on the alarm system.
+  * **Number of the output to switch**
+  * **New /state of the output** ON=1, OFF=0.
+++++
+=== Centrale ===
+After selecting **Security** from the tree, a list of all the alarm devices and centrale added in System will be shown. The available commands when selecting one of the devices are the following:
+++++Arm a particular partition with a specified code|  This command will allow to arm one partition using its related pin code.
+  * **Partition Number**
+  * **Pin Code**
+++++
+++++Disarm a particular partition with a specified code|  This command will allow to disarm one partition using its related pin code.
+  * **Partition Number**
+  * **Pin Code**
+++++
+++++Arm all partitions with a specified code|  This command will allow to arm all partition using a common pin code.
+  * **Pin Code**
+++++
+++++Disarm all partitions with a specified code|  This command will allow to disarm all partition using a common pin code.
+  * **Pin Code**
+++++
+++++Switch ON or OFF the specified output|  This command will allow to control a particular output on the alarm system.
+  * **Number of the output to switch**
+  * **New /state of the output** ON=1, OFF=0.
+++++
 ==== Bentel Interface ====