generic_commands

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision
Previous revision
Next revisionBoth sides next revision
generic_commands [2019/04/02 08:49] – [Reports and Gateways] ingridgeneric_commands [2019/04/02 11:17] – [Reports and Gateways] ingrid
Line 111: Line 111:
   * [[#gateway_modbus| Gateway Modbus]]   * [[#gateway_modbus| Gateway Modbus]]
   * [[#lutron_project| Lutron Project]]   * [[#lutron_project| Lutron Project]]
-  * Serial Gateway +  * [[#serial_gateway| Serial Gateway]] 
-  * Ethernet Gateway+  * [[#ethernet_gateway| Ethernet Gateway]]
   * Gateway MyHome   * Gateway MyHome
   * Voice Control Gateway   * Voice Control Gateway
Line 190: Line 190:
 ++++Stop Raising or Lowering Lights| This command is used to stop raising/lowering the lighting level of the desired output. ++++Stop Raising or Lowering Lights| This command is used to stop raising/lowering the lighting level of the desired output.
   * **Output integration ID** ID of the output to control.   * **Output integration ID** ID of the output to control.
 +++++
 +
 +=== Serial Gateway ===
 +The available commands when selecting the **Serial Gateway** category under **Reports and Gateways** are the following:
 +
 +++++Send string with no termination| This command is used to send a text without termination.
 +  * **String to send** input the string that will be sent to the serial gateway.
 +++++
 +++++Send string with CR termination| This command is used when sending a text with CR termination, marking the end of the line.
 +  * **String to send** input the string that will be sent to the serial gateway.
 +++++
 +++++Send hexadecimal string with no termination| This command is used to send an hexadecimal string without termination.
 +  * **String to send** input the string that will be sent to the serial gateway.
 +++++
 +++++Send hexadecimal string with CR termination| This command is used when sending an hexadecimal string with CR termination, marking the end of the line.
 +  * **String to send** input the string that will be sent to the serial gateway.
 +++++
 +
 +=== Ethernet Gateway ===
 +The available commands when selecting the **Ethernet Gateway** category under **Reports and Gateways** are the following:
 +
 +++++Make an HTTP GET call to a specified url| 
 ++++ ++++
  • generic_commands.txt
  • Last modified: 2022/06/16 08:26
  • by ingrid