generic_commands

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revisionBoth sides next revision
generic_commands [2019/10/21 19:20] ingridgeneric_commands [2019/10/22 12:07] – [Reports and Gateways] ingrid
Line 111: Line 111:
 <WRAP Group> <WRAP Group>
 <WRAP column 30%> <WRAP column 30%>
 +  * [[#hue_gateway| Hue Gateway]]
   * [[#gateway_modbus| Gateway Modbus]]   * [[#gateway_modbus| Gateway Modbus]]
   * [[#lutron_project| Lutron Project]]   * [[#lutron_project| Lutron Project]]
Line 125: Line 126:
 </WRAP> </WRAP>
 </WRAP> </WRAP>
 +
 +=== Hue Gateway ===
 +The available commands when selecting the **Hue Gateway** category under **Reports and Gateways** are the following:
 +
 +++++Turn on/off element|  This command allows to start turn on or off the Hue element. 
 +  * **Value** Write 1 to turn on, and 0 to turn off.
 +++++
 +++++Dimm the element to a value|  This command allows to set the desired value for the dimmer through a single parameter which can assume a value between 0 and 255.
 +  * **Value** can be between 0 and 255.
 +++++
 +++++Set the element color temperature (white)|  This command allows to set the element color temperature. 
 +  * **Value** Can be between 0 and 255, where 0 corresponds to Cold White (6500 K) and 255 correspond to Warm White (2000 K).
 +++++
 +++++Set the element color (RGB)|  Set the element RGB color through the definition of three parameters for Red, Green and Blue. Each color can assume a value between 0 and 255.
 +  * **Red Value** value between 0 and 255.
 +  * **Green Value** value between 0 and 255.
 +  * **Blue Value** value between 0 and 255.
 +++++
 +
  
 === Gateway Modbus === === Gateway Modbus ===
  • generic_commands.txt
  • Last modified: 2022/06/16 08:26
  • by ingrid