Differences

This shows you the differences between two versions of the page.

--- pbx_doorcom [2019/07/22 16:04] – [Integration example: Mobotix T25 doorstation] ingrid
+++ pbx_doorcom [2019/07/22 16:11] – [Integration example: Mobotix T25 doorstation] ingrid
@@ Line 238: / Line 238: @@
 {{ :mx_SIP_client2.png?direct&800 |}}
-<WRAP center important round 60%> If you are unable to view the parameters above, make sure that you scroll down to the "Setup Mode" and select "Expert Mode". </WRAP>
+<WRAP center important round 80%> If you are unable to view the parameters above, make sure that you scroll down to the "Setup Mode" and select "Expert Mode". </WRAP>
 {{ :mx_SIP_client3.png?direct&800 |}}
@@ Line 262: / Line 262: @@
 The final step to be able to make a call from the intercom would be to configure the button on the Mobotix.
 To do that, close the “Admin menu” and instead access the “Setup Menu” from the live interface.
-{{ :mx_setup_menu.png?direct&800 |}}
 Once inside, look for “Event Control” and click on “Action Group Overview”.
+{{ :mx_setup_menu.png?direct&800 |}}
 Click on “Add new group” to create a new entry and name it “Button” or “Bell Button”.
@@ Line 279: / Line 279: @@
 {{ :mx_action_button.png?direct&800 |}}
-<WRAP center round important 60%> Once the configuration is completed, do not forget to store the settings on the Mobotix device. This can be done by going to the Admin Menu and scrolling down to the bottom where you will see the option "Store". A reboot will need to take place after storing. </WRAP>
+<WRAP center round important 80%> It is recommended to tune the microphone and speaker volume on the Mobotix intercom for a good quality call. This can be done by going to the Admin Menu and clicking on "Speaker and Microphone" under "Audio and VoIP Telephony". </WRAP>
+<WRAP center round important 80%> Once the configuration is completed, do not forget to store the settings on the Mobotix device. This can be done by going to the Admin Menu and scrolling down to the bottom where you will see the option "Store". A reboot will need to take place after storing. </WRAP>
 {{ :mx_admin_main.png?direct&800 |}}