Differences

This shows you the differences between two versions of the page.

--- pbx_doorcom [2020/07/20 10:56] – [Adding PBX accounts] ingrid
+++ pbx_doorcom [2020/08/20 13:10] – [Voip PBX & Doorcom] ingrid
@@ Line 10: / Line 10: @@
   * **Intercom devices** This property represents the list of **intercom devices** to be registered in the PBX.
+The diagram below gives a general overview on the configuration when using a Thinknx server as a VoIP PBX.
+{{ :server_pbx_internal.png?direct |Thinknx server used as a VoIP PBX}}
+<WRAP center 60%> <WRAP centeralign> Thinknx server used as a VoIP PBX </WRAP></WRAP>
 ==== Adding PBX accounts ====
@@ Line 113: / Line 117: @@
 To be able to open the Lock connected to the 2N device you have two options: to send **DTMF** tones during conversation or to send html **GET** messages to the device.
-If you want to use DTMF tones, it will be enough to create a Generic Buttom into the UI and select as action the generation of DTMF tone as in the following picture. DTMF code must be the same inserted into the 2N configuration page followed by **#** (in the example 1234#).
+If you want to use DTMF tones, it will be enough to create a Generic Buttom into the UI and select as action the generation of DTMF tone as in the following picture. DTMF code must be the same inserted into the 2N configuration page followed by ***** (in the example 1234*).
 If you prefer to use html GET solution, you need to use the Thinknx Ethernet Gateway plugin and configure a Generic Button to perform an action with the following parameters:
@@ Line 171: / Line 175: @@
 To be able to open the Lock connected to the Doorbird device you have two options: to send **DTMF** tones during conversation or to send html **GET** messages to the device.
-If you wnat to use DTMF tones, it will be enough to create a Generic Buttom into the UI and select as action the generation of DTMF tone as in the following picture. DTMF code must be the same inserted into the Doorbird configuration page followed by **#** (in the example 1234#).
+If you wnat to use DTMF tones, it will be enough to create a Generic Buttom into the UI and select as action the generation of DTMF tone as in the following picture. DTMF code must be the same inserted into the Doorbird configuration page followed by ***** (in the example 1234*).
 {{ :doorbirddtmf.png?direct&800 |}}