proj_creation

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
proj_creation [2019/10/09 01:16] wikiadminproj_creation [2024/05/28 12:09] (current) francesco
Line 17: Line 17:
   * **Step 2** Select the server type (mandatory) and enter the device serial number (optional); go to the next phase by clicking on ”Next” or conclude the wizard by clicking on ”End”; all the following steps are optional .   * **Step 2** Select the server type (mandatory) and enter the device serial number (optional); go to the next phase by clicking on ”Next” or conclude the wizard by clicking on ”End”; all the following steps are optional .
  
 +<WRAP group>
 +<WRAP column half >
 {{ :proj_creation_select_server.png?direct&500 |Step 2: server selection}} {{ :proj_creation_select_server.png?direct&500 |Step 2: server selection}}
 <WRAP center 60%> <WRAP centeralign> Figure 2: server selection </WRAP>  </WRAP> <WRAP center 60%> <WRAP centeralign> Figure 2: server selection </WRAP>  </WRAP>
 +</WRAP> 
 +<WRAP column half> 
 +{{ trend.png?direct500 |Trend Line device selection}} 
 +<WRAP center 60%> <WRAP centeralign> Trend Line device selection</WRAP>  </WRAP> 
 +</WRAP> 
 +</WRAP>
  
   * **Step 3** Enter IP address to connect to the server using the local network or host name and port (if different from the predefined one) to use remote connection.   * **Step 3** Enter IP address to connect to the server using the local network or host name and port (if different from the predefined one) to use remote connection.
  • proj_creation.1570576609.txt.gz
  • Last modified: 2019/10/09 01:16
  • by wikiadmin