Differences

This shows you the differences between two versions of the page.

--- generic_commands [2019/04/02 08:56] – [Reports and Gateways] ingrid
+++ generic_commands [2019/06/19 18:26] – [System] ingrid
@@ Line 87: / Line 87: @@
   * **Email Content** Enter the email content here.
 If the client's house is empty and a presence has been detected inside (1-bit KNX telegram), a scenario can be programmed on the Universal Gateway to send an email to the owner of the house.
+<wrap important>// This command might not work properly. Instead, add an Email Account under System tab, and select the command "send email to recipient" that can be found in the Internal Services. See [[system_objs#email_account| this section]] for more information. //</wrap>
 ++++
 ++++Send DTMF tone during intercom call| This command allows to send a DTMF tone used in telephony while an intercom call is running on the client.
@@ Line 206: / Line 208: @@
 ++++Send hexadecimal string with CR termination| This command is used when sending an hexadecimal string with CR termination, marking the end of the line.
   * **String to send** input the string that will be sent to the serial gateway.
+++++
+=== Ethernet Gateway ===
+The available commands when selecting the **Ethernet Gateway** category under **Reports and Gateways** are the following:
+++++Make an HTTP GET call to a specified url|
 ++++